Jeweler's Rouge

The Science of Metalized Prints Turning a resin or plastic 3D print into a museum-quality metal display requires more than just a dip in a tank. **Electroplating** involves moving metal ions from a source (the anode) to your target object (the cathode) using a precise electrical current. For complex shapes like a Drepanosaurus skeleton, the geometry itself is the enemy. Deep nooks and sharp points create uneven electrical resistance, often resulting in patchy or lumpy finishes. Success demands a balance of chemistry, physics, and patience. Tools and Essential Supplies To begin, you need a **conductive graphite paint** to allow current to flow over the non-conductive plastic. You also require an **electrolyte solution**, specifically a bright acid copper variant, and a **DC power supply** capable of fine-tuning voltage. Your hardware list should include Copper Wire for hanging the piece, **anode sheets**, and Red Jeweler's Rouge for the final polish. Step-by-Step Plating Execution 1. **Preparation**: Apply graphite paint with a brush, ensuring every crevice is covered. Use steel wool to remove patina from your hanging wires and anodes. 2. **The Rig**: Wrap your print loosely with copper wire. Form "lightning rods" by extending wire tips past the print's sharpest points to prevent excess copper buildup. 3. **Initial Submerge**: Place the print between two anodes to eliminate "anode shadows." Set your power supply to a low 0.2 volts. 4. **The Gradient**: Increase voltage in 20-minute increments (0.3v, 0.4v, up to 0.8v). Reposition the piece regularly to ensure the ions reach the internal geometry. 5. **Finishing**: Once fully coated, rinse in distilled water, polish with a rotary tool, and seal with a clear coat to prevent oxidation. Troubleshooting the Shadow and Spike Electricity follows the path of least resistance. Sharp points on a model act as lightning rods, attracting too much copper and becoming "burnt" or lumpy. Conversely, recessed areas—the shadows—get starved of ions. To fix this, always use multiple anodes and manually rotate your part during the process. If you see bare spots, dry the piece and re-apply graphite paint before continuing. Breaking a large, complex model into smaller sections for individual plating often yields a more professional, consistent result.