Dremel Model 580

The Precision of Small-Scale Woodworking There is a specific kind of magic in using small tools for intricate work. While a full-sized cabinet saw is the backbone of any workshop, it feels clumsy and dangerous when you are trying to mill dollhouse-scale lumber or architectural model components. Bringing a vintage Dremel Model 580 table saw back to life is not just about nostalgia; it is about reclaiming the precision necessary for high-level craft. These compact machines allow for a level of tactile feedback and safety that large-scale equipment simply cannot match when the workpieces are measured in millimeters. Essential Restoration Supplies To restore a mini table saw, you need to look beyond the surface. Gather these essentials before you begin: * **Replacement Blade:** A fresh 100mm Carbide Blade is mandatory if the old one has broken teeth. * **Cleaning & Lubrication:** Degreaser, machine oil, and high-quality grease for the internal gears. * **Surface Prep:** A sharpening stone or "stoning" block to flatten the table top. * **Custom Fabrication Materials:** Particle board or plywood for a stable base and hardwood or UHMW plastic for sled runners. * **Internal Upgrades:** A small tension spring to assist the blade return mechanism. Deep Cleaning and Internal Calibration Restoration begins with a total teardown. After sitting for decades, internal lubricants turn into a sticky varnish that bogs down the motor. Open the casing and clear out the accumulated sawdust that inevitably bypasses the internal baffles. During this process, you may find that the blade height adjustment relies solely on gravity. Adding a custom spring return ensures the blade stays seated and does not torque out of alignment when it hits resistance. Once the internals are greased, use a stone to flatten the cast top, removing years of oxidation and small burrs to ensure a frictionless sliding surface. Building the Professional Base and Sled A small saw is often too light, sliding across the workbench during a cut. Bolting the machine to a wider particle board base allows you to clamp the entire unit to your workbench, providing the mass needed for stability. The real performance jump, however, comes from a custom crosscut sled. By fitting tight-tolerance runners into the miter slots and attaching a perpendicular fence, you eliminate the play found in factory miter gauges. The final step is a "zero-clearance" cut: raising the spinning blade through the sled's base to create a slot with no gap. This supports the wood fibers at the exit point, virtually eliminating tear-out on delicate pieces. Operational Benefits and Troubleshooting Once tuned, the Dremel saw should hum with a consistent, high-pitched whir rather than a grinding chatter. If you encounter friction in your sled, identify the high spots on the runners and sand them down until the movement is fluid but has zero side-to-side play. The result is a machine capable of producing repeatable, furniture-grade joinery at a miniature scale. This setup turns a forgotten hobbyist tool into a professional-grade asset for any maker’s shop.