Cell assembly

Monster capacity meets mounting misery The dream of a DIY 30-cell battery pack, theoretically pushing 14.4Ah, sounds like the ultimate power upgrade for any tool bench. On paper, the Fakita battery kit offers a massive 5S6P configuration that should dwarf standard high-output packs. However, the hardware I received is a chaotic mismatch. The provided control PCB simply does not align with the internal mounting pips or screw holes of the battery frame. It’s a classic case of "part-bin engineering" where the seller likely threw incompatible components into a bag and called it a kit. Stubborn silicone blocks reverse engineering Trying to diagnose the board's quality is an exercise in frustration thanks to a thick layer of stubborn silicone. While it provides some moisture protection and secures components against vibration, it makes troubleshooting impossible. Any attempt to scrape it away risks ripping tiny surface-mount resistors right off the pads. This "shmoo" covers the critical voltage monitoring circuitry, effectively locking the design behind a wall of rubbery gunk. If a single component fails under the high load of a 30-cell array, you won't be repairing it; you'll be binning it. Inside the CM1053 management logic Beneath the silicone, the board runs on the CM1053 chip, a standard and generally reliable battery management processor. It utilizes current sense resistors (0.001 ohm total) to monitor load and features a 100K thermistor for thermal protection. However, the design deviates from the official datasheet in its MOSFET gate driving. There is also a concerning diode and resistor path that allows a sub-1mA trickle even when the chip should be shut down. In a remote solar setup, this parasitic creep could eventually overcharge cells if left indefinitely. Final verdict on the 30-cell gamble Despite the allure of 30 18650 cells in a single housing, this kit is a pass. The physical incompatibility requires awkward "bodging" that shouldn't exist in a retail product. While the cell assembly frame itself is decent, the electronics are frustratingly unserviceable and physically mismatched. You are better off using 30 high-quality cells for a custom power bank or a project where the components actually fit the chassis.